Asbestos insulation removal in Auburn, Washington

Typical cost in Auburn

  • Pipe insulation in a basement, about 50 to 150 ft of pipe$1,500 – $4,500+
  • Old boiler or furnace with its insulation and nearby pipe$4,500 – $12,000+
  • Attic vermiculite or loose-fill, about 800 to 1,500 sq ft of attic$8,000 – $20,000+

Asbestos insulation shows up wrapped on heating pipes and boilers, loose in attics and hidden inside walls. Each spot changes how we reach it, how we test it and what follows removal.

We do pipe, boiler and attic jobs in Algona and Pacific too. Share the address and what you plan for the heating system or attic, and we will go from there.

Tell us about your project
Insulated heating pipes in a basement mechanical area

Asbestos insulation removal by location

Pipe and fitting insulation

The straight runs, the elbows and the fittings on one pipe can each be a different insulation. We mark where the work starts and stops, which heating system it belongs to and what stays in place. If another trade is replacing or repairing the pipes, we work out access and when the system is shut off before we book the job.

Boiler and equipment insulation

Work around a boiler or furnace has to fit the heating job. Tell us whether the unit is staying, being replaced or just disconnected. We test the insulation nearby and any surfaces the work touches, and we sort out who gets the equipment ready to come out and who turns the heat back on.

Vermiculite attic insulation

Loose vermiculite in an attic needs a different setup from wrapped pipe. Please do not climb in, move it to get a better photo or bag a sample yourself. Knowing what the attic work is for, such as wiring, vents or new insulation, lets us plan for the access and the disturbance it will cause.

Insulation behind finishes

Opening a wall or ceiling can uncover insulation beyond the area you planned to work in. Before that opening gets any bigger, we test the new material and adjust the plan. We tell your remodeler where the material is and what to stay away from, so regular demolition does not carry on into an untested area.

Coordinate heating and attic access

Before we plan shutdowns, we ask what other trades will do and which systems have to keep running. We work out when you can use the area again and who puts in the new insulation. Any air test or clearance is its own step. The waste receipt and the clearance that lets you use the room again are two different papers.

Survey and project requirements in Washington

The Puget Sound Clean Air Agency handles remodel work and demolition differently. Work on 10 ft of pipe or 48 sq ft or more needs a notice to the agency before it starts. We also confirm the survey and where the insulation waste goes.

We also take out old floor tile, popcorn ceilings and cement siding.

Request a free asbestos removal quote

We recommend calling, but do feel free to contact us using this form. We'll get back to you with a free, personalized quote or additional questions as soon as possible. We're here to help.

Call (253) 294-7929

Call (253) 294-7929